Draytek Vigor3300 Series Manual de usuario descargar pdf (Pagina 75)

2.5.4 port

This command can set port management configuration. After finishing the settings, you have to

reboot to take the changes effect.

port -s

port -r

port <HTTP Enable> <TELNET Enable> <SSH Enable><Use Default Port or Not>

port -p <Http> <Telnet> <SSH>

port -i <Permit IP1>

port -i <Permit IP1> <Permit IP2>

port -i <Permit IP1> <Permit IP2> <Permit IP3>

Syntax Description

-s It is used for displaying current settings.

-r It is used for restarting the router for applying new changes.

-p It is used for configuring port number for HTTP/telnet/SSH.

-i It is used for specifying IP address as network administrator.

Three sets of IP addresses are allowed.

HTTP Enable Accept HTTP protocol as network administration. Enter 1 to

accept it, enter 0 to discard it.

TELNET Enable Accept TELNET protocol as network administration. Enter 1 to

accept it, enter 0 to discard it.

SSH Enable Accept SSH protocol as network administration. Enter 1 to accept

it, enter 0 to discard it.

Use Default Port or Not Enter 0 to use default setting; enter 1 to use customized setting.

0 : Default ; 1 : User Define

Manage from WAN Enter the number to specify the management from WAN.

0 : Disable all from WAN;

1 : Enable all from WAN;

2 : Enable only defined WAN IP;

Http Type the protocol number for HTTP. The default setting is 80.

Telnet Type the protocol number for TELNET. The default setting is 23.

SSH Type the protocol number for SSH. The default setting is 22.

Permit IP1 Type the IP address for the first permitted group, ex. 192.168.1.55

Permit IP2 Type the IP address for the second permitted group, ex.

192.168.1.58

Permit IP3 Type the IP address for the third permitted group, ex.

1 2 ... 70 71 72 73 74 75 76 77 78 79 80 ... 122 123

Sin comentarios

Draytek Vigor3300 Series Manual de usuario Pagina 75