Draytek Vigor3300 Series Manual de usuario descargar pdf (Pagina 63)

2.3.4 policy

This command can configure Load Balance Policy.

policy -s <Index>

policy -used

policy -e <Index> <Protocol> <Source IP><Subnet Mask> <Dest Port Start><Dest Port

End> <Network Interface><Dest IP> <Subnet Mask>

policy -d <Index>

Syntax Description

-s It is used for displaying settings for the specified item.

-used It is used for displaying settings for all the used index entries.

-e It is used for editing the settings of specified item. When you want

to edit the policy, you have to specify two sets of subnet mask.

One is for source IP and the other is for Destination IP.

-d It is used for deleting the settings of specified item.

Index Enter the number (from 1 to 10) that you want to set for specific

configuration.

Protocol Enter the number listed below to specify speicfic protocol.

0 : TCP ; 1 : UDP ; 2 : FTP ; 3 : TFTP ; 4 : HTTP ;

5 : SMTP ; 6 : POP3 ; 7 : TCP/UDP ; 8 : ALL ; 9 : ICMP ;

Source IP Enter the IP address as the source IP.

Subnet Mask Enter the subnet mask for the specified WAN interface.

Dest Port Start Enter a port number as the starting point of the destination. The

range is 1 - 65535

Dest Port End Enter a port number as the ending point of the destination. The

range is 1 – 65535.

Network Interface Enter the number listed below to specify WAN interface for

applying load balance policy.

1 : WAN1 ; 2 : WAN2 ; 3 : WAN3 ; 4 : WAN4

Dest IP Enter the IP address as the destination.

Example

DrayTek/network> policy -s 1

-------------------

Load Balance Policy

-------------------

Index: 1

1 2 ... 58 59 60 61 62 63 64 65 66 67 68 ... 122 123

Sin comentarios

Draytek Vigor3300 Series Manual de usuario Pagina 63