Draytek Vigor3300 Series Manual de usuario descargar pdf (Pagina 117)

112

1: WAN1 ; 2: WAN2 ; 3: WAN3 ; 4: WAN4

Local Subnet Enter a subnet address as local subnet.

Local Subnet Mask Enter the number (0-32) as the local subnet mask.

Remote IP Address Enter an IP Address as remote gateway.

Remote Subnet Enter a subnet address as remote subnet.

Remote Subnet Mask Enter the number (0-32) as the remote subnet mask.

Local Certificate The local certificate is active for authentication if the RSA

Signature option is set in the Authentication field. These options

come from the user certificate file. Enter the number from 1 to 10.

Remote ID Enter the identification number for the remote gateway (ID of

Remote Gateway).

Phase1 Lifetime Enter the rekey-renegotiated period of the IKE Phase1 keying

channel of a connection. Available range is 5-480.

Phase1 Proposal 1 - 4 Enter the number to specify corresponding proposal.

-1: none ;

0: des-md5-modp768 ;

1: des-md5-modp1024 ;

2: des-md5-modp1536;

3: des-sha-modp768;

4: des-sha-modp1024;

5: des-sha-modp1536 ;

Phase2 Lifetime Enter the rekey-renegotiated period of the IKE Phase2 keying

channel. Available range is 5-1440.

Phase2 Proposal 1 - 4 Enter the number to specify proposed encryption and/or

authentication algorithms for IKE Phase2 negotiations.

PFS Enter “0” to enable this function.

Enter “1” to disable this function.

Accepted Proposal If you choose Only accept proposal listed above, only the

selected proposal will be accepted and applied by this device.

If you choose Accept all supported proposal, all the proposals

supported by this device will be accepted and applied.

Enter “0” to enable “Only accept proposal listed above”.

Enter “1” to enable “Accept all supported proposal”.

DPD Enable Enter “0” to enable Dead Peer Detection function.

Enter “1” to disable this function.

Delay Enter “0” to disable this function. Or enter a umber to enable this

function. A Hello message will be emitted periodically when a

tunnel is idle. The recommended value is 30 seconds if enabled.

Timeout Enter “0” to disable this function. Or enter a umber to enable this

function. The recommended value is 120 seconds if enabled.

1 2 ... 112 113 114 115 116 117 118 119 120 121 122 123

Sin comentarios

Draytek Vigor3300 Series Manual de usuario Pagina 117