Draytek Vigor 2200V Guía de instalación descargar pdf (Pagina 17)

1-10

Getting Started

Reset

For upgrading the firmware: Press the button and hold, then power

ON. The ACT and LNK LEDs will blink simultaneously (see section

7.5).

To restore default settings: While the device is running, press the

button and hold for more than five seconds. When the ACT LED be-

gins to blink rapidly, release the Reset button. The router will restart

with the default configuration.

Uplink ... P4

These ports are the same Ethernet port with a mutual crossover. Nor-

mally, the Uplink port should be connected to an external Ethernet

switch/hub, the P4 port should be connected to your PC.

P3, P2, P1

These switch ports should be connected to your local PCs.

WAN LED

ON when the DSL/Cable modem is connected.

Blinking when data packets pass through the port.

WAN

This port should be connected to the Ethernet port of an external

DSL/Cable modem.

ISDN

Connects to an NT1 box provided by your ISDN service provider.

1 2 ... 12 13 14 15 16 17 18 19 20 21 22 ... 139 140

Sin comentarios

Draytek Vigor 2200V Guía de instalación Pagina 17