Draytek Vigor2910 Series Manual de usuario descargar pdf (Pagina 9)

3 IPSec Aggressive Mode Configuration

3.1 Vigor 2910 Configuration

This section describes how to build an IPSec VPN configuration(Aggressive mode) with your

Vigor 2910 VPN router. Refer to http://www.draytek.com/support/index.php for more

information.

Vigor VPN configuration can be achieved with a web browser, so once connected to your VPN

gateway, use the following setup links to configure the VPN.

Advanced Setup > VPN and Remote Access Setup

1. Click on Remote User Profile Setup (Teleworker) link. Then click one index number to open

an individual setup page for a dial-in user account, as shown below.

a. Check the item Enable this account to activate the individual dial-in user account.

b. Enter a number for Idle Timeout. Set it to 0 means no idle timeout.

c. Make sure IPSec Tunnel is selected.

d. Enable Specify Remote Node and type the Peer ID of the VPN client. The corresponding

value set in TheGreenBow is Local ID.

e. Afterward, you should fill a Pre-Shared Key for this specific node. Press the IKE Pre-Shared

Key button and enter the key in the pop-up window.

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17

Sin comentarios

Draytek Vigor2910 Series Manual de usuario Pagina 9