Draytek Vigor2910 Series Manual de usuario descargar pdf (Pagina 4)

2 IPSec Main Mode Configuration

2.1 Vigor 2910 Configuration

This section describes how to build an IPSec VPN configuration(Main mode) with your Vigor

2910 VPN router. Refer to http://www.draytek.com/support/index.php for more information.

Vigor VPN configuration can be achieved with a web browser, so once connected to your VPN

gateway, use the following setup links to configure the VPN.

VPN and Remote Access Setup

1. Click on Remote Dial-in User link. Then click one index number to open an individual setup

page for a dial-in user account, as shown below.

a. Check the item Enable this account to activate the individual dial-in user account.

b. Enter a number for Idle Timeout. Set it to 0 means no idle timeout.

c. Make sure IPSec Tunnel is selected.

d. Enable Specify Remote Node and type the IP address of the VPN client.

e. Afterward, you should fill a Pre-Shared Key for this specific node. Press the IKE Pre-Shared

Key button and enter the key in the pop-up window.

1 2 3 4 5 6 7 8 9 ... 16 17

Sin comentarios

Draytek Vigor2910 Series Manual de usuario Pagina 4